Assembling And Hanging The Fan - Hunter 21361 Owners And Installation Manual

WARNING: Fan may fall if not assembled as directed in these
installation instructions .
3-1 . Unbundle the wires from the fan .
For Standard or Angled mounting:
3-2 . Insert the downrod through the canopy and canopy trim ring .
Feed the wires from the fan through the downrod on one side of
the pin in the ball .
3-3 . Loosen the square head setscrew on the adapter to install the pipe
and ball assembly . Note: When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is normal .
Securely retighten the setscrew with a wrench or pliers . Skip to
step 3-7 .
CAUTION: The adapter has a special coating on the threads . Do
not remove this coating; the coating prevents the downrod from
unscrewing . Once assembled, do not remove the downrod .
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the
low profile washer .
3-4 . Remove the setscrew from the adapter .
3-5 . Place the low profile washer into the canopy with the lip down .
3-6 . Align the holes in the washer with the holes in the adapter .
Assemble securely with three low profile screws .
Hanging the Fan:
Note: To hang the fan, you must tilt the canopy to an almost vertical
position so that the canopy slots sit on the ceiling plate hooks .
3-7 . Raise the fan and align the slots in the canopy with the hooks on
the ceiling plate .
3-8 . Place the slots over the hooks to hang the fan .
3 • Assembling and Hanging the Fan
8
42671-01 • 05/27/10 • Hunter Fan Company
Standard or Angled Mounting
Steps 3-2 – 3-3
Setscrew
Low Profile Mounting
Steps 3-5 – 3-6
Low Profile Screws
Green
Ground
Wire
Canopy
Trim Ring
Low Profile Screw
Step 3-6 (Detail)
Low Profile Screw
Adapter
Downrod
Canopy
Canopy
Trim Ring
Low Profile
Washer
Canopy
Low Profile
Washer