How To Fill Rinse Aid; How To Fill The Detergent - Teka DW6 Use And Maintenance Manual

How to fill rinse aid

Rinse aid
This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on
the inside panel of the door .
When the low rinse aid indicator
rinse aid .
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading
the rinse aid.
To open the dispenser, turn the
direction and then pour in the rinse aid, making sure not to
overfill. The amount of rinse aid used for each cycle can be
regulated by turning the
the "1" cap, with a screwdriver.
There are 6 different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage
adjuster should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjuster to a lower setting.

How to fill the detergent

Detergent
Detergent specifically intended for use with dishwashers must
be used. The dispenser must be refilled before the start of
each wash cycle following the instructions provided in the
"Programme overview". The detergent dispenser is located on
the inside panel of the door.
Loading the detergent
To open the "3" cover on the dispenser, press the "4"
button.
The detergent for the wash cycle should be poured into
the "5" compartment.
The detergent for the pre-wash cycle should be poured
into the "6" compartment.
After the detergent has been placed in the dispenser,
close the cover and press down until it clicks in place.
9
ìDî lights , you must load
"1" cap in an anti-clockwise
"2" dose adjuster, located beneath
D
1 2
4
3
6
5