Electrolux EIDW1805KS Service Data Sheet page 2

Color Code
To start...... Close and latch door. Press START/CANCEL pad.
BK............. Black
To delay start.... Close and latch door. Press DELAY START pad
BL............. Blue
to select desired delay time.
BN............ Brown
To select a new
P................ Purple
cycle or option.... Press desired cycle and/or option pad. The
R............... Red
indicator lights will change. Press START/CYCLE
W........... White
within 15 seconds to begin cycle.
R/Y..... Red/Yellow
To cancel cycle.... Press START/CANCEL. Dishwasher will drain
Y............. Yellow
for 90 seconds, then shut off.
For controls
lock........................ Press and hold the AIR DRY pad for 8 seconds.
To unlock, press and hold AIR DRY pad for 8 sec.
Water/Service Test
The water/service test is a special
function initiated from the power
failure mode or idle mode.
While in power failure or idle mode -
simultaneously press the AIR DRY and
FILL/DISPENSER
START/CANCEL pads for 1 1/2 seconds. 1
2 DISPENSER
The dishwasher will then step through
3 WASH/HEAT
the test cycle per the chart. Pushing the
4 PAUSE
START/CANCEL pad will advance the
5 WASH/HEAT
dishwasher to the next step.
6 WASH/HEAT/DISP
7 DRAIN/DRY
8 DRY
CLEAN LED stay on for 30 seconds after door is opened or cycle started.
Operation
WASHING
CLEAN
OPTION LED's Flashing
STATUS LED's Flashing
LOW RINSE --------------------- The liquid rinse aid agent is low. Light will switch off after 5 complete wash cycles or dispenser is filled.
(Some models)
SANITIZED --------------------- The SANITIZED criteria has been met. Indicator light will switch off when door is opened.
30 1 0 0 0 0 0 1 0
30 0 1 0 1 1 0 1 0
45 0 0 0 1 0
0 1 0
.4 0 1 0 1 0 0 0 0
75 0 1 0 1 1 0 0 0
Hi temp wash
60 0 0 1 0 0 0 0 0 THERMISTOR
90 0 0 1 0 1
0 0 1
90 0 0 0 0
0 X 0 0
X - denotes selectable option
Cycle Selection Options
----------------------Wash portion of cycle.
------------------------ Shows completion of cycle. Indicator light will switch off when door is opened.
-- HI-TEMP WASH and NO HEAT DRY/POWER DRY OFF LED's flashing indicates power failure has occurred. Press START/CANCEL
pad and reselect desired options and cycle.
-- The STATUS LED's that are lit when the door is opened will flash. Close door.
Wiring Diagram
Display Codes (LED)