Series Record And Split Slave Control Modes; Series Record; Split Slave - Focus DR-HD100 - Firestore - Data Storage Wallet User Manual

Series Record and Split Slave Control Modes

Two additional control modes are available when the DR-HD100
is teamed up with the JVC GY-HD camcorder:
. To access these control modes, select either

Split Slave

mode from the GY-HD camcorder's
Split
menu. The DR-HD100 must be in
modes to function, see "JVC GY-HD" on page 32.

Series Record

Series Record automatically starts recording to disk when a tape is close
to the end of the record session. For more information about what
happens once recording to disk begins, refer to the camcorder
documentation.
Split Slave
In Split Slave mode, the GY-HD camcorder controls the DR-HD100
separately from the camcorder's tape transport. The DR-HD100 is
slaved to the camcorder's
GY-HD's left panel.
• Every time the Rec Trigger is pressed, the DR-HD100 begins
recording in the selected recording mode.
• When the Rec Trigger is pressed again, the DR-HD100 enters
REC/PAUSE
Record mode.
• Pressing the Rec Trigger a third time, restarts recording. A
new track is created on the disk. Refer to camcorder
documentation for more information.
GY-HD Camera's OTHERS→BACK SPACE[HDV] Setting
When using this mode, be certain to set the GY-HD's OTHERS→BACK
SPACE[HDV] menu to P-1394.
With this setting there is a slightly delayed response to the record
trigger.However, when OTHERS→BACK SPACE[HDV] is set to P-
TAPE, the stream that the DR-HD100 records will contain
discontinuities at every point that recording to tape is initiated. This will
result in the loss of content.
ProHD DR-HD100 Portable DTE Recorder
REC TRIGGER
mode. The only exception is if it is in Retro
Series Record
1394 REC TRIGGER
mode for these
JVC GY-HD
button, located on the
Quickstart
and
or
Series
33