Connecting a DR-HD100 to a DV/HD
Camcorder
Before performing this procedure, make sure you have installed and
charged the battery, see "Installing / Removing the Battery Pack" on
page 21.
Step 1:
Connect the supplied Firewire cable to the "DV I/O" connector
on the top of the DR-HD100.
Step 2:
Locate the FireWire/DV/iLink (or similar) connector on your
video camera. It is located in different places depending upon the
brand of camera. If you are unclear of its location, consult your
video camera manual.
DR-HD100 Supplied with 6-pin to 6-pin FireWire Cable
A 6-pin to 6-pin FireWire, 1394, cable is provided with the
DR-HD100.
GY-HD FireWire Connector
The FireWire connector on the GY-HD cameras is located on the
right side of the camera, behind the tape transport. For more
information, refer to the GY-HD documentation.
Step 3:
Connect the other end of the FireWire, 1394, cable to your video
camera.
Step 4:
Turn on the video camera.
Step 5:
Turn on the DR-HD100.
ProHD DR-HD100 Portable DTE Recorder
Quickstart
23