DR-HD100 Functions
TC SET
The Timecode Set parameter stores a user defined timecode in the
DR-HD100's non-volatile memory. This value is available for use by
the DR-HD100 immediately after exiting
•
TC FREE RUN
The DR-HD100 uses this value on the next recording after it
is set in
•
TC REGEN
This is the starting value when using an empty hard disk
drive for recording.
•
TC REC RUN
This is the value used to begin every recording session after a
power cycle.
The TC SET value is only actively applied when the unit is in
DV RECORDER mode.
72
TC SET
00 : 00 : 00 : 00
HH : MM : SS : FF
.
TC SET
ProHD DR-HD100 Portable DTE Recorder
BACK
.
TC SET