Table of Contents
Advertisement
• If you are installing a memory module, open the retaining clips of the memory slot into which you
want to install the memory module.
Figure 46. Opening the retaining clips
9. Position the new memory module over the memory slot. Make sure that the notch
module aligns correctly with the slot key
down into the slot until the retaining clips close.
Figure 47. Installing a memory module
10. To complete the installation or replacement, go to "Completing the parts replacement" on page 141.
Installing or replacing a PCI card
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre User Guide. To obtain a copy of the ThinkCentre User Guide, go to:
http://www.lenovo.com/ThinkCentreUserGuides
This section provides instructions on how to install or replace a PCI card. Your computer has two PCI
Express x1 card slot and one PCI Express x16 graphics card slot.
To install or replace a PCI card, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 113.
118
ThinkCentre Hardware Maintenance Manual
2
on the system board. Push the memory module straight
1
on the memory
Hide quick links:
Advertisement
Table of Contents
