Installing A Memory Module - IBM x3500 - System - 7977 User Manual

6. Carefully grasp the Remote Supervisor Adapter II SlimLine by its top edge or
7. Press the Remote Supervisor Adapter II SlimLine firmly into the connector and
8. Close the rear adapter retention bracket.
If you have other optional devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 46.

Installing a memory module

The following notes describe the types of dual inline memory modules (DIMMs) that
your server supports and other information that you must consider when you install
DIMMs:
v The server supports up to twelve 667 MHz, 1.8 V, 240-pin, PC2-5300
v At least one pair of DIMMs must be installed for the server to operate.
upper corners, and align it with the Remote Supervisor Adapter II SlimLine
guide and the connector on the system board.
Attention: Incomplete insertion might cause damage to the system board or
the adapter.
under the retention clip on the Remote Supervisor Adapter II SlimLine support
bracket.
double-data-rate (DDR) II, fully buffered synchronous dynamic random-access
memory (SDRAM) with error correcting code (ECC) DIMMs. These DIMMs must
be compatible with the latest 5300 SDRAM Fully Buffered DIMM (FBD)
specification. For a list of supported optional devices for the server, see
http://www.ibm.com/servers/eserver/serverproven/compat/us/.
Remote Supervisor II
SlimLine adapter
Remote Supervisor II
SlimLine adapter retainer clip
Remote Supervisor II
SlimLine adapter support bracket
Chapter 2. Installing optional devices
33