Position the new memory module over the memory connector. Make sure
system board. Push the memory module straight down into the connector
until the retaining clips close.
5. Refer to the "Completing the installation".
Replacing the hard disk drive
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at
To replace the hard disk drive:
Remove the computer cover. Refer to "Removing the computer cover".
Note: For this procedure, it helps to lay the computer on its side.
Hardware Replacement Guide
31039394_3000 H_HRG_EN_V2.0.indd16 16
on the memory aligns correctly with the connector key
2009.7.14 4:15:49 PM