Haier HPRD12XC7 - 12000 BTU Portable AC User Manual page 12

English
Control Panel
Power Control
The power control turns the unit on and off.
Warning Light
Condensed water may accumalate in the unit. If
the internal tank becomes full, the Warning signal
in the LCD Display will light the unit
Mode Control
The mode control has 3 settings:
• Cool • Dehumidifier • Heating (only
HPRD12XH7)/Fan
The settings are adjusted with Mode Control
button. A green light will indicate which setting
is currently being used.
Cooling Mode
When the cool mode is selected, "
in the LCD Display. During the cooling mode the
air is cooled and hot air is exhausted to the ou-
tiside through the exhaust tube adjust fan speed
and air temperature to suit your desired comfort
level.
Note: The air exhaust hoses must vent outside the
room when using cool mode.
Dehumidifier Mode
When dhumidify mode is selected, "
show inthe LCD display. Air is dehumidified as
it passes through the unit, without being in full
cooling mode. If room temperature is higher than
77˚ C, fan speed can be adjusted: otherwise fan
88˚ F
speed is fixed to "Low".
88˚ F
Note: The warm air exchange hoses must vent 88hr
88˚ F
inside the room when using Dehumidify Mode,
88hr
not outside as it does when cooling. If the unit is
88hr
vented outside some cooling will occur.
Fan Mode (Led in Yellow)
When fan mode is selected "
be shown in the LCD display, air is circulated
throughout the room with no cooling.
10
(continued)
88˚ F
88hr
" will show
88˚ F
88hr
" will
", " ", " " will
88hr
Heating Mode (Led in Red) (only HPRD12XH7)
In heating mode " ", the air flow is selectable.
(Note: Heating is activated only when the
ambient temperature is below 77° F.)
Fan Speed Control (Led in Yellow)
The Fan Speed Control has 3 settings: High,
Medium. and low.
Timer
Auto turn off:
With machine in running mode, press timer button
for setting timer control. Press "
select number of hours you would like the unit to
run before it automatically shuts off.
Auto turn off:
With machine in stand by mode, press timer
button for setting timer control. Press "
to select number of hours before the unit
automatically starts running in air conditioning
mode.
Note: The time is adjustable between 1-24 hours.
Temperature Controls
• Used for adjusting the thermostat
• The default display is room temperature
• In cooling mode, when "
pressed, the set temperature is displayed and may
be adjusted. After 15 seconds the display will
revert back to room temperature. Temperature is
only adjustable in cool mode.
Note: by pressing both "
the same time for more than 3 seconds, the
display will toggle between Celsius and
Fahrenheit.
" or " " to
" or " "
" or " " button is
" / " " buttons at