Important Safety Instructions For Use Of The Battery And Battery Charger; Caution On Lithium-Ion Battery - Hitachi G18DL - 18V Cordless Lithium Ion HXP 4-1/2" Grinder Instruction Manual

Cordless
Table of Contents

Advertisement

Available languages

Available languages

*
If the input rating of a battery charger is given in
watts rather than in amperes, the corresponding
ampere rating is to be determined by dividing the
wattage rating by the voltage rating–for example:
1,250 vatios
125 voltios
9.
Do not operate battery charger with damaged cord
or plug-replace them immediately.
10. Do not operate battery charger if it has received a
sharp blow, been dropped, or otherwise damaged
in any way; take it to a qualified serviceman.
11. Do not disassemble battery charger; take it to a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk
of electric shock or fire.
12. To reduce risk of electric shock, unplug charger
from receptacle before attempting any
maintenance or cleaning. Removing the battery
will not reduce this risk.
IMPORTANT SAFETY INSTRUCTIONS FOR
USE OF THE BATTERY AND BATTERY
CHARGER
You must charge the battery before you can use the
power
tool.
Before
UC18YRL battery charger, be sure to read all instructions
and cautionary statements on it, the battery and in this
manual.
REMEMBER: USE ONLY HITACHI BATTERY TYPES EB7
SERIES, EB9 SERIES, EB12 SERIES, EB14 SERIES, EB18
SERIES, AND EBM1830. OTHER TYPES OF BATTERIES
MAY BURST AND CAUSE INJURY!
Follow these instructions to avoid the risk of injury:
WARNING: Improper use of the battery or
battery charger can lead to serious
injury. To avoid these injuries:
1. NEVER
disassemble the battery.
2. NEVER
incinerate the battery, even if it is
damaged or is completely worn out. The
battery can explode in a fire.
3. NEVER
short-circuit the battery.
4. NEVER
insert any objects into the battery
charger's air vents. Electric shock or
damage to the battery charger may
result.
5. NEVER
charge outdoors. Keep the battery away
from direct sunlight and use only where
there is low humidity and good
ventilation.
6. NEVER
charge when the temperature is below
32°F (0°C) or above 104°F (40°C).
7. NEVER
connect two battery chargers together.
= 10 amperios
using
the
model
8. NEVER
insert foreign objects into the hole for
the battery or the battery charger.
9. NEVER
use a booster transformer when
charging.
10. NEVER
use an engine generator or DC power to
charge.
11. NEVER
store the battery or battery charger in
places where the temperature may reach
or exceed 104°F (40°C).
12. ALWAYS operate charger on standard household
electrical power (120 volts). Using the
charger on any other voltage may
overheat and damage the charger.
13. ALWAYS wait at least 15 minutes between
charges to avoid overheating the
charger.
14. ALWAYS disconnect the power cord from its
receptacle when the charger is not in
use.

CAUTION ON LITHIUM-ION BATTERY

To extend the lifetime, the lithium-ion battery equips
with the protection function to stop the output.
In the cases of 1 and 2 described below, when using
this product, even if you are pulling the switch, the motor
may stop. This is not the trouble but the result of
protection function.
1.
When the battery power remaining runs out (The
battery voltage drops to about 12V (G18DL) / about
8V (G14DL)), the motor stops.
In such case, charge it up immediately.
2.
If the tool is overloaded, the motor may stop. In
this case, release the switch of tool and eliminate
causes of overloading. After that, you can use it
again.
Furthermore, please heed the following warning and
caution.
WARNING
In order to prevent any battery leakage, heat generation,
smoke emission, explosion and ignition beforehand,
please be sure to heed the following precautions.
1.
Make sure that swarf and dust do not collect on
the battery.
During work make sure that swarf and dust do not
fall on the battery.
Make sure that any swarf and dust falling on the
power tool during work do not collect on the
battery.
Do not store an unused battery in a location
exposed to swarf and dust.
Before storing a battery, remove any swarf and
dust that may adhere to it and do not store it
together with metal parts (screws, nails, etc.).
2.
Do not pierce battery with a sharp object such as a
nail, strike with a hammer, step on, throw or
subject the battery to severe physical shock.
3.
Do not use an apparently damaged or deformed
battery.
English
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G 18dlG 14dl

Table of Contents