Related Manuals for Hitachi G 10SS2
Summary of Contents for Hitachi G 10SS2
- Page 1 G 10SS2・G 12SS2・G 13SS2 fi Handling instructions...
-
Page 2: General Power Tool Safety Warnings
Carrying power tools with your fi nger on the switch GENERAL POWER TOOL SAFETY or energising power tools that have the switch on WARNINGS invites accidents. d) Remove any adjusting key or wrench before WARNING turning the power tool on. Read all safety warnings and all instructions. -
Page 3: Safety Warnings Common For Grinding Or Abrasive Cutting- Off Operations
l) Never lay the power tool down until the accessory SAFETY WARNINGS COMMON FOR has come to a complete stop. GRINDING OR ABRASIVE CUTTING- The spinning accessory may grab the surface and pull the power tool out of your control. OFF OPERATIONS m) Do not run the power tool while carrying it at your side. -
Page 4: Additional Safety Warnings Specific For Abrasive Cutting- Off Operations
c) The guard must be securely attached to the power – Inspect the grinding wheel before use, do not use tool and positioned for maximum safety, so the least chipped, cracked or otherwise defective products; amount of wheel is exposed towards the operator. –... -
Page 5: Standard Accessories
Thickness 4 mm 6 mm Peripheral speed 72 m/s 80 m/s Weight (only main body) 1.7 kg 1.8 kg NOTE Due to HITACHI’s continuing program of research and development, the specifi cations herein are subject to change without prior notice. -
Page 6: Mounting And Operation
3. Inspecting the carbon brushes For your continued safety and electrical shock protection, carbon brush inspection and replacement on this tool should ONLY be performed by a HITACHI AUTHORIZED SERVICE CENTER. 4. Replacing supply cord If the replacement of the supply cord is necessary, it has to be done by Hitachi Authorized Service Center to avoid a safety hazard. - Page 8 G10SS2 G12SS2 G13SS2 Ø16 Ø16 Ø20 Ø20 G10SS2 G10SS2 G12SS2 G13SS2 G12SS2 G13SS2 G10SS2 G12SS2 G13SS2 Ø20 Ø16 G10SS2 G12SS2 G13SS2...
- Page 9 15° – 30°...
- Page 10 G10SS2 : 338856 G12SS2 : 338848 G13SS2 : 338845 G10SS2 : 320497 G12SS2, G13SS2 : 937817Z G10SS2 : 321795 G12SS2, G13SS2 : 994324 G10SS2 : 313933 G12SS2, G13SS2 : 938332Z 302142 G10SS2 : 302099 G12SS2 : 332785...
- Page 12 Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99712212 G Printed in China...