Optimizing RGB Picture Automatically
Adjusting the Image Using Auto Adjust
Optimizing an RGB image automatically.
Press the Auto Adjust button to optimize an RGB image automatically.
[Poor picture]
[Normal picture]
Press the Auto Adjust button to fine-tune the computer image or to remove any vertical band-
ing that might appear and to reduce video noise, dot interference or cross talk (this is evident
when part of your image appears to be shimmering). This function adjusts the clock frequen-
cies that eliminate the horizontal banding in the image. This function also adjusts the clock
phase to reduce video noise, dot interference or cross talk. (This is evident when part of your
image appears to be shimmering.)
This adjustment may be necessary when you connect your computer for the first time.
NOTE:
• Some signals may not be displayed correctly or take time.
• The Auto Adjust function does not work for component and video signals.
• If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Clock and Phase manually.
See page 84.
Turning Up or Down Volume
Sound level from the speaker and the AUDIO OUT
jack (Stereo mini) on the projector can be adjusted.
3. Projecting an Image (Basic Operation)
SELECT
SOURCE
AUTO ADJUST
LAMP
STATUS
POWER
3D REFORM
ON/STAND BY
PC CARD
Increase volume
Decrease volume
37
OFF
ON
POWER
AUTO ADJ.
VIDEO
COMPUTER
1
2
S-VIDEO
COMPONENT
SELECT
PJ
3D REFORM
SOURCE
ASPECT
POINTER
VIEWER
VOLUME MAGNIFY
SLIDE
PICTURE
FREEZE
PIC-MUTE
HELP