Remote Control Operation; Operating Range; Turning On The Button Backlight; Resetting To The Factory Default Settings - Panasonic PTAE2000 Operating Instructions Manual

Remote control operation

Operating range

Turning on the button backlight

In a dark room, you can turn on the button
backlight to operate the remote control.
Press the LIGHT button on the upper right
corner of the unit to turn on the backlight and
enter the light-on mode.

Resetting to the factory default settings

You can reset most of the customized
settings to the factory defaults by pressing
DEFAULT button of the remote control.
Display the required sub-menu or the menu
items and press the button again.

Capturing an image

When projecting an image, press FREEZE
button to capture the projected image and
display it on the screen as a still picture. Press
again to escape.
E
22 - NGLISH
You can operate the projector with the remote control
within the remote range 7 m (22'11").
Facing to the projector
Ensure the remote control emitter is facing to the
remote control signal receptor on front/back of the
projector and press the required buttons to
operate.
Facing to the screen
Ensure the remote control emitter is facing to the
screen and press the required buttons to operate
the projector. The signal will be reflected off the
screen. The operating range may differ due to the
screen material. This function may not be effective
with a translucent screen.
NOTE:
• Do not let strong light shine onto the signal receptor.
The remote control may malfunction under strong light
such as fluorescent.
• If there are any obstacles between the remote control
and the remote control signal receptor, the remote
control may not operate correctly.
After 30 seconds without any operation, the backlight will
go out and press any but the LIGHT button to turn on
again. To escape from the light-on mode, press the
LIGHT button.
NOTE:
• Some menu items are not available to reset by pressing
the DEFAULT button. Adjust each menu items
manually.
You can adjust AREA SELECT of the SPLIT ADJUST
menu by pressing the ENTER button while the frozen
image is displayed. See "SPLIT ADJUST" on page 32.