Control Commands; Cable Specifications - Panasonic PT-LB55NTE Operating Instructions Manual

Control commands

The commands which the personal computer can use to control the projector
are shown in the following table.
Command Control Contents
PON Power ON
POF Power OFF
AVL Volume
Input signal
IIS
selection
Lamp ON
Q$S
condition query
OSH Shutter function

Cable specifications

(When connected to a personal computer)
In standby mode, all commands other than
the PON command are ignored.
B The PON command is ignored during
lamp ON control.
B If a PON command is received while the cooling
fan is operating after the lamp has switched off,
the lamp is not turned back on again straight
away, in order to protect the lamp.
Parameter
000-063 (Adjustment value 0-63)
Parameter
VID=VIDEO
RG1=PC1
NWP=WIRELESS
Callback
0 = Standby
1 = Lamp ON control active
2 = Lamp ON
3 = Lamp OFF control active
Operation will be switched between ON and OFF each
time the command is sent. Do not switch operation ON
and OFF after only short periods of time.
If a command other than "OSH" is sent to the projector
when the shutter function is used, the "ER401"
command will be sent from the projector to the
computer and the shutter function will be turned off.
At the projector
1
2
3
4
5
6
7
8
Remarks
SVD=S-VIDEO
RG2=PC2
At the computer
(DTE specifications)
7
8
3
5
2
6
1
4
9
E
NGLISH
-71