Selecting The Input Signal - Panasonic PT-LB55NTE Operating Instructions Manual

Selecting the input signal

(INPUT SELECT/ DIRECT INPUT SELECT)
You can select the input signal by pressing the INPUT SELECT button or the
DIRECT INPUT SELECT buttons.
Projector control
panel
NOTE:
B"PC2" cannot be selected when "PC2 SELECT" in the "OPTION" menu is
set to "OUTPUT".
30-E
NGLISH
Press the INPUT SELECT button.
BThe input signal selected will change as shown
below each time the INPUT SELECT button is
pressed.
INPUT SELECT
button
Control
panel
Remote
control
unit
Press the DIRECT INPUT SELECT buttons.
BYou can select the input signal directly.
DIRECT INPUT
SELECT buttons
Remote
control
unit
Changing signals
Changing signals
The signal that is being input to the
PC 1 IN connector will be projected.
The signal that is being input to the
PC 2 IN connector will be projected.
The signal that is being input to the S-
VIDEO IN connector will be projected.
The signal that is being input to the
VIDEO IN connector will be projected.
The signal that is set by the wireless
network will be projected. (page 56)