Replacing The Fuse - JVC DLA-L20U - D-ila Projector--3:1-6:1 Lens,2000 Lumen Instructions Manual

Replacing the Fuse

A fuse is used to protect the power source of the projector. If the fuse is burned out, replace it. When the power switch
is turned on but no power is supplied to the projector, check the fuse. When replacing the fuse, obtain the same type
of fuse rated 15 A/250 V. If there are any unclear points, contact the dealer where you purchased your projector.
1 Turn off the main power switch and
disconnect the power cord from
both the projector and the wall
outlet.
Place the main power switch to the OFF
2
Loosen the fuse holder to remove
it.
To loosen the fuse holder, use a Philips screwdriver.
3 Remove the fuse from the fuse
holder you just removed.
4 Install the new fuse into the fuse
holder.
5 Reinstall the fuse holder into the
projector.
60
[‡ ‡ ‡ ‡ ‡ ]
position.
Fuse (15A, 250V)
Fuse holder
Philips screwdriver
Fuse (15A, 250V)
Fuse holder
Fuse holder