PROJECTOR SETUP menu
Remote control
See "Navigating through the menu" on page 34.
See "Main menu and Sub-menu" on page 32.
STATUS
You can see the status of the projector about the
following items.
Items
SIGNAL
NAME
Projecting signal name
FREQUENCY
Projecting signal frequency
RUNTIME
PROJECTOR
Duration of projector used time
LAMP
Duration of lamp used time
REMAINING FILTER
QUANTITY
Quantity of filter remaining
Control panel
Description
COMPUTER2 SELECT
You can switch the function of the COMPUTER2 IN/
1 OUT terminal.
INPUT
COMPUTER2 IN
OUTPUT
COMPUTER1 OUT
NO SIGNAL SHUT-OFF
You can set the timer to switch off the power of the
projector after a certain period of time automatically
when no signal is detected. Press I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
DISABLE
FG
15 MIN.
FG
20 MIN.
FG
25 MIN.
FG
30 MIN.
FG
35 MIN.
INITIAL START UP
You can select how the projector start when the mains
lead is connected.
Options
Start as the same mode as the
LAST MEMORY
last switched off.
STANDBY
Always start in standby mode.
Always start in projecting
ON
mode.
FG
60 MIN.
FG
55 MIN.
FG
50 MIN.
FG
45 MIN.
FG
40 MIN.
IH
Description
E
NGLISH - 43