Read This First; Minimum Required Setting Screen - Panasonic PT-F300EA Operating Instructions Manual

Read this first

Minimum required setting screen

When you start the projection for the first time, the minimum required setting screen for projection will be displayed.
INITIAL SETTING
1. Select the required language setting by pressing
I H, then press the ENTER button.
INITIAL SETTING
ENGLISH
PLEASE SELECT LANGUAGE
SELECT
2. Select the minimum required settings to start the
projection.
Press the RETURN button to return to the language
setting menu.
Press F G to move through the menu items.
Press I H to select the required setting.
Press the ENTER button to complete the setting and
start the projection.
INITIAL SETTING
INSTALLATION
HIGH ALTITUDE MODE
SWITCH TO HIGH ALTITUDE MODE "ON" IF OVER 1400m(4593Ft).
SELECT
NOTE:
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is
initialised. See "INITIALIZE ALL" on page 45.
You can change the each setting from the main menu. See "Menu Navigation" on page 32.
ENTER
FRONT/DESK
OFF
RETURN
ENTER
INSTALLATION
Select the required installation method.
Setting on a desk/floor and
FRONT/DESK
projecting from front
Mounting on the ceiling and
FRONT/CEILING
projecting from front
Setting on a desk/floor and
REAR/DESK
projecting from rear
Mounting on the ceiling and
REAR/CEILING
projecting from rear
HIGH ALTITUDE MODE
If you use the projector at high elevation, the HIGH
ALTITUDE MODE setting need to be ON to set the fan
speed high.
OFF The fan speed is low.
ON The fan speed is high.
NOTE:
• At 1 400 - 2700 m (4 593 - 8 858 ft) above sea level,
the setting must be ON.
• The loudness of fan noise depends on the HIGH
ALTITUDE MODE setting.
E
NGLISH - 13