Initial Startup - Hayward Spa Heaters Owner's Manual

Initial Startup

?
IMPORTANT
Before starting the pool heater for the first time, it is important to verify that
the breaker is in the On position.
Also make sure that the water circulates freely and that the pool pump is activited.
Then, you will need to set the water temperature you desire. The fan will
immediately start. The compressor will start after a 3 to 4-minute delay.
When the compressor is running, the HEATING/CHAUFFAGE indicator located
on the right (see "Service Analyzer Control," p. 13) should be lit. At initial startup,
it is normal for the unit to run 24 hours a day.
It is also normal to see water dripping from the holes at the base of the unit.
This is just condensation.
17
OWnER'S MAnUAL