Super Io Configuration; Onboard Floppy Controller - Biostar N68S3B Bios Manual

N68S3B BIOS Manual
SuperIO Configuration
Advanced
Configure ITE8718 Super IO Chipset

Onboard Floppy Controller

Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
Keyboard PowerOn
Mouse PowerOn
Restore on AC Power Loss
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Onboard Floppy Controller
Select enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you installed another FDC or the system uses
no floppy drive, select disabled in this field.
Options: Enabled (Default) / Disabled
Parallel Port Address
This item allows you to determine access onboard parallel port controller with which
I/O Address.
Options: 378 (Default) / 278 / 3BC / Disabled
Parallel Port Mode
This item allows you to determine how the parallel port should function.
Options: Normal (Default)
EPP
ECP
ECP+EPP
ECP Mode DMA Channel
This item allows you to select parallel port ECP DMA.
Options: DMA3 (Default) / DMA0 / DMA1
BIOS SETUP UTILITY
[Enabled]
[378]
[Normal]
[IRQ7]
[Disabled]
[Disabled]
[Power Off]
Using Parallel port as Standard Printer Port.
Using Parallel Port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as ECP & EPP mode.
9
Allows BIOS to Enable
or Disable Floppy
Controller
Select Screen
Select Item
Change Option
+-
F1 General Help
Save and Exit
F10
Exit
ESC