Gigabyte GA-78LMT-S2PT User Manual page 31

Port4 as ESP/Port5 as ESP
&
This option is configurable only when OnChip SATA Type is set to AHCI and OnChip SATA Type Port4/5
is set to As SATA Type. Enabled will speed up the hot plug detection of the connected SATA device.
(Default: Disabled)
SMART LAN (LAN Cable Diagnostic Function)
&
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Start detecting at Port.....
Part1-2 Status = Open / Length =
Part3-6 Status = Open / Length =
Part4-5 Status = Open / Length =
Part7-8 Status = Open / Length =
: Move Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN cable.
This feature will detect cabling issue and report the approximate distance to the fault or short.
Onboard LAN Function
&
Enables or disables the onboard LAN function. (Default: Enabled) If you wish to install a 3rd party add-in
network card instead of using the onboard LAN, set this item to Disabled.
Onboard LAN Boot ROM
&
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard Audio Function
&
Enables or disables the onboard audio function. (Default: Enabled)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
USB Controllers
&
Enables or disables the integrated USB controllers. (Default: Enabled)
Disabled will turn off all of the USB functionalities below.
USB Legacy Function
&
Allows USB keyboard to be used in MS-DOS. (Default: Enabled)
USB Storage Function
&
Determines whether to detect USB storage devices, including USB flash drives and USB hard drives during
the POST. (Default: Enabled)
Onboard Serial Port
&
Enables or disables the first serial port and specifies its base I/O address and corresponding interrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
&
Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and corresponding
interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
&
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)
(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
SMART LAN
0m
0m
0m
0m
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 31 -
Item Help
Menu Level ``
ESC: Exit F1: General Help
F7: Optimized Defaults