Gigabyte GA-78LMT-S2PT User Manual page 18

9) IDE (IDE Connector)
The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before attaching
the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE devices, remember
to set the jumpers and the cabling according to the role of the IDE devices (for example, master or slave).
(For information about configuring master/slave settings for the IDE devices, read the instructions from the
device manufacturers.)
10) CLR_CMOS (Clear CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and reset the
CMOS values to factory defaults. To clear the CMOS values, use a metal object like a screwdriver to touch
the two pins for a few seconds.
Always turn off your computer and unplug the power cord from the power outlet before clearing
•
the CMOS values.
After system restart, go to BIOS Setup to load factory defaults (select Load Optimized
•
Defaults) or manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS
configurations).
40 39
2 1
Open: Normal
Short: Clear CMOS Values
- 18 -