Table of Contents
Advertisement
Creating a RAID 0 set (striped)
To create a RAID 0 set:
1.
From the utility main menu, select 1. Create RAID Volume, then press
<Enter>. This screen appears.
Intel(R) Matrix Storage Manager Option ROM v5.0.0.1032 ICH9R wRAID5
Copyright(C) 2003-05 Intel Corporation. All Rights Reserved.
Enter a string between 1 and 16 characters in length that can be used
to uniquely identify the RAID volume. This name is case sensitive and
[↑↓]-Change
2.
Enter a name for the RAID 0 set, then press <Enter>.
3.
When the RAID Level item is highlighted, press the up/down arrow key to
select RAID 0(Stripe), then press <Enter>.
4.
When the Disks item is highlighted, press <Enter> to select the hard disk
drives to configure as RAID. This pop-up screen appears.
Port Drive Model
0 XXXXXXXXXXXX
1 XXXXXXXXXXXX
2 XXXXXXXXXXXX
3 XXXXXXXXXXXX
[↑↓]-Previous/Next
5.
Use the up/down arrow key to highlight a drive, then press <Space> to
select. A small triangle marks the selected drive. Press <Enter> after
completing your selection.
ROG Blitz Formula
[ CREATE ARRAY
Name:
Volume0
RAID Level:
RAID0(Stripe)
Disks:
Select Disks
Strip Size:
128KB
Capacity:
0.0
Create Volume
[ DISK/VOLUME INFORMATION
cannot contain special characters.
[TAB]-Next
[ESC]-Previous Menu
[ SELECT DISKS
Serial #
XXXXXXXX
XXXXXXXX
XXXXXXXX
XXXXXXXX
Select 2 to 4 disks to use in creating the volume.
[SPACE]-Selects
MENU ]
GB
]
[Enter]-Select
]
Size Status
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
[ENTER]-Selection Complete
5-33
Advertisement
Table of Contents
