Configuring Your Wireless Network; Accessing Your Router After Installation And Checking For New Firmware - NETGEAR WNDR3700v3 Setup Manual

After installing your router, you must log into the router to complete your wireless setup. When
you log in to the browser, you will be prompted to check for firmware updates from the
NETGEAR update server.
Accessing Your Router After Installation and
Checking for New Firmware
The Smart Wizard only appears when you run the CD. If you want to change the settings after
installing and configuring your router, you can click the desktop shortcut—a pre-configured
shortcut placed on your desktop by the Smart Wizard at installation—to open the router
management interface.
settings, by opening a browser window and logging in to the router. You will also be prompted to
check for new router firmware for the router.
To log in to the router after installation:
Open a browser window and type http://www.routerlogin.net in the address field of your
1.
browser. Press Enter.
You can enter either of these addresses to connect to your wireless router:
http://www.routerlogin.net or http://www.routerlogin.com.
When prompted, enter the Password (
2.
the default router Password), both in lowercase letters. If you changed the Password from the
defaults, then enter your new Password.
The router User Name and Password are unique to the router and are not the
same as any other User Name or Password you may use to log in to your
Internet connection.
1. The shortcut icon is installed on your desktop only when using the Smart Wizard installation method.

Configuring Your Wireless Network

Configuring Your Wireless Network
1 You can also change your settings, or configure your wireless and security
admin
is the default router User Name and is
password
19