Installing The Handle; Fitting The Engine With Oil; Setup - Toro 20334 - Personal Pace Electric Start Walk Power Mower Operator's Manual

Setup
Important:
Remove and discard the protective
plastic sheet that covers the engine.
1
nstalling the Handle
No Parts Required
Procedure
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
, Remove the handle _obs from the mower housing
(Figure 3).
Important:
Route the cables to the outside of
the handle knobs as you install the handle.
i
G009550
Figure 3
2. Move the handle to the operating position.
3. Install and tighten the handle _obs that you
removed in step I .
[2
Filling the Engine with Oil
No Parts Required
Procedure
Important:
Your mower does not come with oil
in the engine, but it does come with a bottle of oil.
Before starting the engine, fill the engine with oil.
Max. fill: 20 oz. (0.59 1), type: SAE 30 detergent oil
with an API service classification of SF, SG, SH, SJ, SL,
or higher.
Note:
When the crankcase is empb, pour about 3/4 of
the crankcase capacity of oil in the crankcase, then do
the following:
1. Move the mower to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out (Figure 4).
1.
Figure 4
Dipstick
,
4.
Wipe the dipstick clean with a clean cloth.
Insert the dipstick flay into the oil fill tube, then
remove the dipstick.
5. Read the oil level on the dipstick.
Note: If the oil level is below the Add mark on
the dipstick, slowly pour a small amount of oil into
the oil fill tube, wait 3 minutes, and repeat steps 3
through 5 until the oil level is at the Full mark on the
dipstick (Figure 4).