Brother HL 5370DW - B/W Laser Printer Network User's Manual page 112

f
Wait until the Status LED of your machine indicates Connected. The Status LED will turn on for 5
minutes. (See the table below) This indication means the machine has successfully connected to your
access point/router. You can now use your machine in a wireless network.
If the LED indicates Connection Fail (See the table below), the machine has not successfully
connected to your access point/router, or the entered PIN code is invalid. Make sure you enter the
correct PIN code, and try starting from c again. If the same message is indicated again, reset the print
server back to its factory default settings and try again. For resetting, see Reset the network settings to
the factory default on page 118.
If the LED indicates No Access Point (See the table below), the machine has detected no access
point/router on your network. Make sure you place the Brother machine as close to the network access
point/router as possible with minimal obstructions, and try starting from c again. If the same message
is indicated again, reset the print server back to its factory default settings and try again. For resetting,
see Reset the network settings to the factory default on page 118.
LED indications when using the one-push wireless setting mode
LEDs
Setting WLAN
Back Cover
Toner
(Yellow)
Drum
(Yellow)
Paper
(Yellow)
Status
(Red or
Green)
1
The LED will blink (turn on for 0.2 seconds and off for 0.1 second).
2
The LED will turn on for 5 minutes.
3
The LED will blink (turn on for 0.1 second and off for 0.1 second) for 30 seconds.
You have completed the wireless setup. To install the printer driver, Go to step a on page 103
®
for Windows or page 107 for Macintosh.
Wireless configuration using the PIN Method of Wi-Fi Protected Setup (For HL-5370DW)
1 2
Connected
Connection
No Access Point
3
Fail
7
7
3
102