Rio RECEIVER Frequently Asked Questions Manual page 6

NOTE: You should keep your Windows Installation or Recovery CD handy as you may
be prompted to load drivers from it.
5. Windows will finish installing the Rio Connector.
The Audio Receiver Manager Software
NOTE: (For pre-existing Home PNA or Ethernet networks only.) Before installing the
Audio Receiver Manager software, it is required that all HPNA or Ethernet
network connections be made and working correctly so that the Audio
Receiver Manager software can properly configure the Rio Receiver's network
connection. See the HPNA or Ethernet hardware manufacturer's
documentation for instructions on how to install and configure your network.
1. Insert the Rio Receiver Installation CD in the CD-ROM drive.
2. When the Rio Receiver splash screen appears, click the Software Installation button.
(If it does not automatically run, click the Start button in the bottom left corner of the desktop and then
Run. Type in D:\Setup.exe and click OK. If your CD-ROM drive is a letter other than D, replace D with that
letter.)
3. Click the Rio Software button. The Installation Wizard screen will appear.
4. Click Next.
You will be prompted to read through the Audio Receiver Manager software license agreement
5. Click Yes.
When you are prompted to select the destination folder for the program, we recommend leaving it at the
default folder (c:\Program Files\Audio Receiver), but you can change the destination folder by clicking the
Browse button and pointing the installation program to your preferred destination.
6. Click Next and then click Finish.
The Audio Receiver Manager will place a red musical note icon
bottom corner of the desktop and then prompt you with the following message.
7. Click OK. The Select Music Locations screen will come on with a list of the hard drives located on your
computer.
Installation
Return to Pg.1
in the PC's system tray in the right
Page 6