Cruise Control; Headlamps, High Beam - Buick PARKAVE GTK 2004 Getting To Know Manual

Moisture-Sensing Delay Windshield
Wipers (optional)
The moisture-sensing wiper system
monitors the moisture on the windshield
and adjusts the wipers accordingly. The
wipers will wipe once to indicate that this
feature is on.
Activating the System:
Turn the WIPER band to one of the five
sensitivity levels within the DELAY area.
The wipers will make one wipe to indi-
cate it is on. The DELAY position closest
to OFF/MIST is the lowest sensitivity
setting and allows more rain to accumu-
late before the wipers actuate. Rotating
the WIPER band away from you will
increase the sensitivity and frequency
of wipes.
Note: Turn the wiper band to OFF to
avoid wiper damage when going
through an automatic car wash.
See Section 3 of your Owner Manual.

Cruise Control

Set Cruise Control
1. Move the CRUISE CONTROL switch
to ON. Accelerate to the desired
speed.
2. Push in the SET button on the end of
the lever and release it. The cruise
control light on the instrument cluster
will illuminate. Remove your foot from
the accelerator pedal.
Resume Set Speed
To resume a set speed after the brakes
have been applied, move the CRUISE
CONTROL switch from ON to R/A
(Resume/Accelerate) and release. The
vehicle's preset speed will resume.
OFF
Move the CRUISE CONTROL switch to
OFF.
Applying the brakes will also turn cruise
control off.
See Section 3 of your Owner Manual.

Headlamps, High Beam

High/Low Beam Changer
Pull the turn signal lever toward you until
it clicks to change from low beam to
high beam.
Flash-To-Pass
Pull the turn signal lever toward you
slightly to flash the high beam
headlamps.
See Section 3 of your Owner Manual.
11