Door Panel - Dometic RM2191 & RM2193 Installation & Operating Instructions Manual

F. Replace door on lower hinge pin. Replace upper hinge
pin and bushings removed in Step A.
G. Check that the door closes properly and seals all
around.
13. INSTALLATION OF DECORATIVE

DOOR PANEL

The door panel can easily be mounted. The dimensions
of the panel must be:
Height .......................... 19-3/4"
Width ............................ 17-27/32"
Thickness ..................... Up to 1/8"
Weight .......................... 49 lbs.
SECTION B. CERTIFIED VENT SYSTEMS SECTION B. CERTIFIED VENT SYSTEMS
SECTION B. CERTIFIED VENT SYSTEMS SECTION B. CERTIFIED VENT SYSTEMS SECTION B. CERTIFIED VENT SYSTEMS
REFRIGERATOR REFRIGERATOR REFRIGERATOR
REFRIGERATOR REFRIGERATOR
MODEL MODEL MODEL MODEL MODEL
RM2191
RM2193
* Requires one each
** Alternative instructions forwarded with ventilator kit. Used in conjunction with upper and lower side
vents, at minimum vent heights.
SECTION C. SECTION C. OPERA SECTION C.
SECTION C. SECTION C.
1. 1. 1. 1. 1. IMPOR IMPORT T T T T ANCE OF LEVELING A IMPOR IMPOR ANCE OF LEVELING A ANCE OF LEVELING A
IMPOR ANCE OF LEVELING A ANCE OF LEVELING A
REFRIGERA REFRIGERAT T T T T OR REFRIGERA
REFRIGERA REFRIGERA
In an absorption refrigerator system, ammonia is liquefied
in the finned condenser coil at the top of the refrigerator.
The liquid ammonia then flows into the evaporator (inside
the freezer section) and is exposed to a circulating flow of
hydrogen gas, which causes the ammonia to evaporate,
creating a cold condition in the freezer.
The tubing in the evaporator section is specifically sloped
to provide a continuous movement of liquid ammonia
downward by gravity through this section. If the refrigera-
tor is operated when it is not level and the vehicle is not
moving, liquid ammonia will accumulate in sections of the
COMPONENTS COMPONENTS COMPONENTS COMPONENTS COMPONENTS
* RM123 Upper side vent
* RM183 Lower side vent
** Power Ventilator
OPERA OPERATING INSTR OPERA
OPERA
OR OR OR
OR
A. Remove the door. See Section 12.
B. Remove the lower trim molding. (NOTE: Trim
molding is not installed on new units in cartons)
C. Fit the new panel in place and slide it up as far as
possible.
D. Fit the trim molding back in place.
PART NO. PART NO. PART NO. PART NO. PART NO.
8030211.331
8030211.332
3104726.009
TING INSTRUCTIONS TING INSTR TING INSTR
TING INSTR
evaporator tubing. This will slow the circulation of hydro-
gen and ammonia gas, or in severe cases, completely
block it, resulting in a loss of cooling.
Remember to level the vehicle when stopping for more
than an hour, otherwise the cooling unit could be perma-
nently damaged due to overheating if it is left "ON".
When the vehicle is moving, the leveling is not critical as
the rolling and pitching motion of the vehicle will pass to
either side of level, keeping the liquid ammonia from
accumulating in the evaporator tubing.
7
UCTIONS UCTIONS UCTIONS
UCTIONS