Removal And Installation Of Refrigerator - Dometic RM182B Service Manual

REMOVAL AND INSTALLATION OF REFRIGERATOR

C.
Remova 1
1.
Disconnect electrical supply. And make sure the
its source.
2.
Remove the vent /air-intake assembly on the van
a. Unscrew three self-tapping screws (A,Fig.2)
then remove windscreen and separating plate
b. Unscrew four screws (D,Fig.2) of the fixing
fixing plate and gasket (F, Fig. 2) from the
the vent casing (H,Fig. 2).
3.
Open and remove all three doors of the kitchen cabinet (Fig.3). Pull out dra-
wer. Dismantle and remove shelves. Then lift door from hinge posts (Fig.3).
4.
Remove three protective caps (A, Fig.4) from the refrigerator frame (B,Fig.4)
and unscrew the three screws that are behind the caps. Then on each side
through the doors, unscrew two phillips screws (C, Fig.4) from the walls of
the refrigerator.
5.
pull refrigerator frame forward in the lower right (Fig. 5,arrow A)
t en pull out the left groove according to arrow (B,Fig.S) toward the right.
6.
Remove 120 V connection plug (A, Fig.6) from the socket, pull out 12 V plug
connection (B, Fig.6).
Unscrew threaded union of the gas-connection line (C,Fig.6) of the refrige-
rator.
7.
Unscrew ventilation grill (A. Fig. 7) by removing two screws (B, Fig. 7) and
then remove refrigerator by pulling forward.
Installation
The installation is carried out in the reverse sequence to that described for
the removal of the refrigerator.
IMPORTANT:
After installation, check gas system for leaks, with soapy water.
NEVER USE A MATCH
-5-
gas supply is shut off at
wall outside .
of the windscreen (B,Fig.2)
(C, Fig. 2).
plate (E,Fig. 2) and remove
caravan wall (G, Fig. 2) to