Table of Contents
Advertisement
QUICK START GUIDE
Windscreen Holder Installation
The car mount has a suction pad that fits to the windscreen or a flat area on the
dashboard.
A. Fitting to windscreen
Pull the lever away from the suction pad. Place the pad on the widescreen and push the
lever towards the pad until it clicks into place.
B. Fitting the holding bracket
It is best to fit this to the unit before it is attached to the windscreen.
Slide the bracket onto the securing lug on the end of the ball mount at the end of the car
mount and then push down firmly, until it clicks in to place. The bracket can only be fitted
one way.
C. Fitting the Unit
Slide the unit into the bottom of the bracket and carefully push the unit up and back until it
clicks into place at the top.
To remove the unit from the car mount; Press and lift the tab at the top of the bracket then
pull the unit forward and out of the bottom of the bracket.
To remove the Car mount from the windscreen; Lift the lever away from the windscreen,
then gentle pull the tab on the suction cup to release the suction as you pull the mount
away from the windscreen.
Advertisement
Table of Contents
