Binatone E3200 Manual page 7

Color profile: Generic CMYK printer profile
Composite Default screen
6
Fit a battery pack in each handset
A. Plug in the
B. Tuck the wires in
connector
and lay the battery
pack in the
compartment
C. Fit the battery
compartment
cover, sliding it into
place and pressing
firmly to make sure
BLACK RED
it is secure
7
Charge the batteries for 15 hours
Before you use the handset for the
first time, it is important to charge
the batteries fully.
The battery
level symbol
The handset 'beeps' when it's correctly
blinks
in position on the charging cradle.
Leave the handset on the charging
cradle for 15 hours.
The BATTERY ICON will go up one bar every half
hour when charging an empty battery. Remove
and refit battery if you think BATTERY ICON is not
showing correct charge level even after charging.
8
Connect the base unit to the telephone line
Switch off power at the mains socket
Insert the telephone line plug into
the socket as shown
Switch mains power back on
Make sure the mains socket is
switched on if you want to use
the phone — it will not work
without electrical power
Binatone Help Line: 01325 304 473
E:\Binatone2003\e3400\e3400_07.vp
11 March 2003 10:11:56
The Charge
light comes
on.
Use the plug to
raise the shutter
before pushing
it into the socket
NOTE: the charger pod does not have
a connection to the tele p hone line.
5