I/O Shield; I/O Shield Dimensions (For Boards With The Lan Subsystem) - Intel D845HV Technical Product Specification

Intel Desktop Board D845HV/D845WN Technical Product Specification

2.10.3 I/O Shield

The back panel I/O shield for D845HV and D845WN boards must meet specific dimension and
material requirements. Systems based on this board need the back panel I/O shield to pass
certification testing. Figure 19 shows the critical dimensions of the chassis-dependent I/O shield
for boards with the onboard LAN subsystem. Figure 20 shows the critical dimensions of the I/O
for boards without the onboard LAN subsystem. Dimensions are given in inches to a tolerance of
±0.02 inches.
The figure also indicates the position of each cutout. Additional design considerations for I/O
shields relative to chassis requirements are described in the ATX specification. See Section 1.4 for
information about the ATX specification.
NOTE
The I/O shield drawings in this document are for reference only. An I/O shield compliant with the
ATX chassis specification 2.01 is available from Intel.
0.884
[22.450]
0.276
[7.012]
0.00
0.465
[11.811]
0.567
[14.400]
Figure 19. I/O Shield Dimensions (for boards with the LAN Subsystem)
76
6.390 Ref
[162.300]
0.787±0.010 TYP [20±0.254]
0.039 Dia. [1.000]
3x Dia 0.330 [8.380]
0.063±0.005
[1.600±0.120]
8X R0.5 MIN
0.519
[13.190]
0.027
[0.690]
1.89
Ref
0.465
[11.811]
0.567
[14.400]
0.621
[15.770]
Pictorial
View
OM12352