Controls; Instrument Panel - HYOSUNG SD 50 Manual

3.CONTROLS

INSTRUMENT PANEL

① SPEEDOMETER
The speedometer indicates the road speed in
kilometers per hour.
② ODOMETER
The odometer registers the total distance that the
motorcycle has been ridden.
③ FUEL GAUGE
It indicates the remaining fuel amount in the fuel
tank. E indicates the fuel tank is empty or nearly
so. (the remaining fuel is 0.8ℓ at E. the capacity
is 4.8ℓ) Fill the fuel tank before E.
▲CAUTION
!
The fuel gauge indicates the remaining
amount whenever the ignition switch is
"ON" or "OFF" . For checking the remaining
amount of fuel, put the motorcycles on the
center-stand and set the ignition switch is
"ON" .
④ TURN SIGNAL INDICATOR LIGHT
When turn signals are being operated. the indica-
tor will flash intermitently.
⑤ OIL INDICATOR LIGHT
When the engine oil level in the tank becomes
too low requiring "HYPOL OIL"refilling. the indi-
cator will light. When the oil level check light
turns on, the remaining amount of oil has become
approximately 300㎖.
▲CAUTION
!
The lack of Engine oil could cause serious dam-
ages on the Engine.
① IGNITION SWITCH
The ignition switch has three positions:
LOCK
"ON"POSITION
The ignition circuit is completed and the engine can
now be started. The key cannot be removed from
the ignition switch in this position.
"OFF"POSITION
All electrical circuits are cut off.
"LOCK"POSITION
To lock the steering, turn the handlebar all the way
to the left. Push down and turn key to the "LOCK"
position and remove the key. All electrical circuits are
disconnected.
PUSH
7
SWITCH
ON
KEY