Windshield Washer Fluid; Adding Washer Fluid - GMC YUKON XL 2004 Owner's Manual

Windshield Washer Fluid

What to Use
When you need windshield washer fluid, be sure to read
the manufacturer's instructions before use. If you will be
operating your vehicle in an area where the temperature
may fall below freezing, use a fluid that has sufficient
protection against freezing. See Engine Compartment
Overview on page 5-12 for reservoir location.

Adding Washer Fluid

Your vehicle has a low washer fluid message that
comes on when the washer fluid is low. The message is
displayed for 15 seconds at the start of each ignition
cycle. When the CHECK WASHER FLUID message is
displayed, you will need to add washer fluid to the
windshield washer fluid reservoir.
Open the cap with the washer symbol on it. Add washer
fluid until the tank is full.
5-40
The windshield washer
fluid reservoir is located in
the engine compartment
toward the front of the
vehicle on the driver's side.
Notice:
•
When using concentrated washer fluid, follow the
manufacturer's instructions for adding water.
•
Do not mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and
damage your washer fluid tank and other parts of
the washer system. Also, water does not clean as
well as washer fluid.
•
Fill your washer fluid tank only three-quarters full
when it is very cold. This allows for expansion if
freezing occurs, which could damage the tank if
it is completely full.
•
Do not use engine coolant (antifreeze) in your
windshield washer. It can damage your washer
system and paint.