Rainsense™ Ii Windshield; Wipers; Heated Windshield Washer Fluid; Rear Vision Camera - GMC YUKON 2008 Getting To Know Manual

18
Getting to Know Your Yukon/Yukon Denali
Rainsense™ II Windshield
Wipers (if equipped)
The Rainsense II windshield wipers use
a moisture sensor to automatically oper-
ate the wipers when needed, depending
on driving conditions and the sensitivity
setting. If the system is left on for long
periods, an occasional wipe may occur
without any moisture on the windshield
to indicate the system is activated.
The headlamps also will be turned on
automatically when the Rainsense
wipers are active if the exterior lamp
control knob is in the AUTO position.
Windshield Wiper Controls
The controls for the windshield wipers
are located on the multifunction lever on
the left side of the steering column. The
band can be rotated to the following
positions:
(Mist): Rotate the wipers band
down to this position to turn the wipers
on for one wipe.
(Off): Rotate the wipers band to this
position to turn the wipers off.
(Sensitivity Setting): Rotate the
control band up to one of the sensi-
tivity levels to activate the Rainsense
function. The position closest to Off is
the lowest sensitivity level.
(Low): Rotate the wipers band up
to this position to turn on the wipers to
the Low speed setting.
(High): Rotate the wipers band
up to this position to turn on the wipers
to the High speed setting.
(Washer): Push the paddle on top
of the multifunction lever to spray wash-
er fluid on the windshield.
See Section 3 of your Owner Manual.

Heated Windshield Washer Fluid

(if equipped)
Press the (Heated Washer Fluid)
button, located below the climate con-
trols on the instrument panel, to spray
heated washer fluid on the windshield.
This will help to clear ice, tree sap or
bugs from the windshield. A light on the
switch will flash while the washer fluid is
heating, which may take up to 40 sec-
onds. The wipers will automatically turn
on for four cycles or until the button is
pressed again.
See Section 3 of your Owner Manual.

Rear Vision Camera

(if equipped)
The rear vision camera displays a view
of the area behind the vehicle on the
navigation screen when the vehicle is
shifted into Reverse. Once shifted out of
Reverse, the navigation screen will
return to the last screen displayed after
approximately 10 seconds.
To turn the camera on or off:
1. Shift into Park.
2. Press the Menu hard key to enter the
Menu options.
3. Press the Menu hard key to select
Display, or touch the Display screen
button.