Led And Sound Indicators; Setting Up Your Camera; Installing The Batteries - Insignia NS-DSC10B - Digital Camera - Compact User Manual

NS-DSC10A-10B_09-0323_MAN_V2.book Page 3 Monday, April 27, 2009 8:42 AM
Insignia NS-DSC10A and NS-DSC10B 10 Megapixel Digital Cameras

LED and sound indicators

Your camera gives feedback to users in two ways:
• LED Indicators
• Sound indicators
LED Indicators
Your camera is equipped with two LED indicators:
• An operation LED, located on the back of your
camera. See "Back"on page 2 to locate the
operation LED,
• A self-timer LED, located on the front of the
camera. See "Front"on page 1 to locate the
Self-timer LED.
LED LED status
Off
Green (steady)
Operation
Green (fast blink)
Green (slow blink)
Off
Self-timer
Amber (blinking)
Sound indicators
Your camera is equipped with a buzzer to provide
sound indicators.
Sound indicator Camera status
An operation, such as recording, has started. Also indicates using
One beep
a menu and setting properties.
An operation is complete.
Two beeps
A low battery or other warning. Also indicates error messages,
Three beeps
such as memory full or card error.
When the self-timer is set, the camera beeps every second of the
countdown between ten and four seconds left. It beeps every
Continuous beep
half second when the countdown reaches three seconds. The
beep stops after the countdown completes.
The shutter is pressed to record an image.
Shutter sound

Setting up your camera

Installing the batteries

To install the batteries:
1 Make sure that your camera is turned off.
2 Open the battery cover by sliding it in the
direction indicated in the illustration.
Camera status
Power off
Power on, ready to take pictures, record,
or playback.
Camera busy or deleting/copying/
recording/transferring data.
In Record mode, flash is charging, or AF
error.
Self-timer off.
Self-timer countdown is set. The LED
blinks faster as the countdown reaches its
end.
www.insigniaproducts.com
3 Insert two AA batteries into the battery
compartment. Make sure that you match the +
and – symbols on the batteries with the + and –
symbols in the battery compartment.
4 Close the battery cover.
5 If you are replacing the batteries, go to the Setup
menu and make sure the battery type selected
matches the type of batteries you inserted in
the camera. (See "Using the Setup and Tools
menus" on page 13)
Warning
Be sure to use only alkaline, NiMH, or lithium
batteries with your camera. Failure to do so may
damage your camera or cause risk of injury to
yourself and others.
Notes
• A low battery indicator
LCD when the batteries are nearly exhausted.
Batteries should be replaced promptly when
this indicator appears.
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is depleted.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery compartment
with a cloth. If chemicals touch your skin, wash
immediately.
• If the camera is not going to be used for an
extended period of time, remove the batteries.
• The camera body may feel warm to the touch
after extended use. This is normal.
appears on the
3