The Control Panel - Epson PhotoPC - Color Digital Camera User Manual

EPSON PhotoPC
Note the following when handling batteries:
Do not use manganese batteries.
Replace all four batteries at the same time.
Do not drop, puncture, disassemble, or mutilate batteries.
or expose them to fire.
Do not get them wet
When the camera is not used for long periods of time,
remove the batteries and store them at a low temperature
in a dry location.
Dispose of used batteries according to the battery
manufacturer's instructions and in compliance with all
applicable laws. Contact your local government agency
for information about battery recycling and disposal.
If you use rechargeable Ni-Cad batteries, replace them
with four fully-charged batteries. If you find that your
batteries run out faster after you recharge them a number
of times, make sure you discharge them completely before
recharging.
Checking the Battery Icon
Before you take pictures, check the battery icon on the
control panel. The icon shows how much battery power you
have left, in the following four stages:
Full battery power (or AC adapter in use)
power is decreasing
Battery
Battery power is almost out

The Control Panel

The control panel keeps track of how many pictures have
been taken and gives important information about the status
of battery and various settings.
the
EPSON PhotoPC-2
The Control Buttons
You adjust the following settings using the control
can
buttons on the top of the camera:
All control button settings (except the timer) remain in effect
even after you turn off the camera. However, they return to
their factory settings when you remove or
batteries.
resolution
Flash
The built-in flash has these three settings,
within a range of 3 to 10 feet:
Auto sets the flash to go off automatically whenever
$ it's needed (factory setting)
Forced flash sets the flash to go off for every picture.
Flash
off disables the
lighting.
Resolution
The PhotoPC has the following two resolution settings:
High resolution images are captured at 640
camera can hold up to 16 pictures at high resolution
Standard resolution images are captured at 320
the camera can hold up to 32 pictures at this
resolution
Timer
The timer sets a lo-second delay between the time the
shutter button is pressed and the image is captured.
Erase
Press the erase button with a small pointed object to erase a
picture from the camera's memory.
12/95
change the
erase
timer flash
are effective
which
even in inadequate
flash
480; the
x
Digital Camera
240;
x