Caring For Your Monitor; Preparing The Monitor For Wall-Mounting - Lenovo 4449HB1 User Manual

Caring for your monitor

Be sure to turn off the power before you perform any maintenance on the monitor.
Do not:
•
•
•
•
•
Do:
•
•

Preparing the monitor for wall-mounting

Detaching the monitor stand:
Step 1: To detach the base by pressing the button as shown in Figure 1.
Step 2: Press the cable clip upwards and remove it as shown in Figure 2.
Step 3: open the support garnish by pushing it upward as shown in
Figure 3 (after hearing a chirpping sound).
Step 4: Screws connecting the support to the display will be fully exposed.
Remove the screws and then the support can be disassembled
as shown in Figure 4.
LCD wall-mounting instructions:
1.The gap between the installation holes on the back of the LCD is 75 *75mm.
There should have corresponding position of holes on the wall-mounting plate.
2.The installation holes on the back of the LCD should be of regular M4 thread.
Select the corresponding screws to use.
3.The effective depth of the threaded holes on the back of the LCD is 8 mm,
the length of the thread of the fixing screw is recommended as follows:
L = 8 mm + installation plate thickness - (1~2) mm.
4.Remove the base and the support. See descriptions on the above illustration.
5.Insert the screw for fixing through the round hole on the wall-mounting plate and
screw it onto the installation hole on the back of the LCD and then tighten it.
6.There are four fixing screws.
Cable clip usage instructions:
First take out the cable clip as shown in Figure 1. After connecting the power cord and the signal cable,
put the remaining cable in the back of the support garnish as shown in Figure 2. Use the cable clip to wrap
the remaining cable and position them in the slot of the support garnish as shown in Figure 3.
Apply water or liquid directly to your monitor.
Use solvents or abrasives.
Use flammable cleaning materials to clean your monitor or any other electrical
equipment.
Touch the screen area of your monitor with sharp or abrasive items. This type of
contact may cause permanent damage to your screen.
Use any cleaner which contains an anti-static solution or similar additives. This
may harm the coating of the screen area.
Lightly dampen a soft cloth with water and use this to gently wipe the covers and
the screen.
Remove grease or finger marks with a damp cloth and a little mild detergent.
Wall-mount the
Secure the screws
installation plate
(4 screws)
2-9
Chapter 2.