Table of Contents
Advertisement
Menu Configuration—SET-UP MENU
For the operation procedure, see page 7.
Operation guide
Shows the buttons for each
operation.
• The menu automatically disappears in about 30 seconds after the previous operation.
• Some items may not appear on the menu depending on the input or the input signal.
• The items controlled by the MAKE system do not appear on the menu.
NOTE
Settings of "sub menu POSI."
The setting values and features are as follows.
LOWER1:
Displays the current setting and adjustment bar at the lower part of the screen.
UPPER1:
Displays the current setting and adjustment bar at the upper part of the screen.
LOWER2:
Displays the current setting at the lower part of the screen.
UPPER2:
Displays the current setting at the upper part of the screen.
• The adjustment bar is not displayed for some items.
Settings of "SD4:3 LARGE"
The setting values and features are as follows.
OFF:
Fit the vertical picture size into the pixel numbers of the monitor display.
ON:
Fit the vertical picture size into that of the monitor display.
FUNCTION SETTING
Settings for the sub menu display, color system, color of the tally lamp, picture size, intensity of the button lamps
and the PHASE adjustment.
Item
To do
sub menu
Select the contents and displaying position of "sub menu."
POSI.
COLOR
Select the color system.
SYSTEM
• If the picture is unstable with "AUTO," select "NTSC" or "PAL."
TALLY SELECT Select the color of the tally lamp.
SD4:3 LARGE
Change the picture size of 4:3 format signal.
DIMMER
Select the intensity of the button lamps.
COMPONENT
Deactivates the function of PHASE adjustment (Picture adjustment knob
PHASE
and "PICTURE SUB ADJ." in SET-UP MENU) except when an NTSC
signal comes in (☞ 3 on page 6).
PICTURE SUB ADJ.
Adjusts the standard level for the picture adjustment and selects the set-up level for the input video signal.
Item
To do
CONTRAST*
1
Adjust the standard level for the contrast adjusted with the
CONTRAST knob on the front panel.
BRIGHT*
1
Adjust the standard level for the brightness adjusted with the
BRIGHT knob on the front panel.
CHROMA*
1
Adjust the standard level for the chroma adjusted with the CHROMA
knob on the front panel.
PHASE*
1,
*
2
Adjust the standard level for the phase adjusted with the PHASE
knob on the front panel.
NTSC SETUP
Select the set-up level of the input NTSC signal.
COMPO. LEVEL Select the level of the analog component signal (480i and 576i only). B75 (compliant
sub menu
Display the sub menu which enables you to adjust the items in "PICTURE SUB ADJ." while
viewing the actual picture.
reset
Restore the default settings for all the items in "PICTURE SUB ADJ."
*
Memorized for each input.
1
*
2
When "COMPONENT PHASE" is set to "DISABLE" and an NTSC signal is input, PHASE can be adjusted.
Setting value
☞ "NOTE"
AUTO, NTSC, PAL
GREEN, RED
☞ "NOTE"
NORMAL, DARK
ENABLE, DISABLE
Setting value
–20 – +20
–20 – +20
–20 – +20
–20 – +20
00 (compliant with
0% set-up signal),
7.5 (compliant with
7.5% set-up signal)
with BetacamVTR
7.5% set-up signal),
B00 (compliant
with BetacamVTR
0% set-up signal),
SMPTE (compliant
with M2VTR signals)
17
Advertisement
Table of Contents
