Cable Installation
Please follow these instructions to install the cables.
1. Remove the back panel
2. Place the signal cable, the DC power cable into their correct respective grooves.
Connecting the Display to your Computer
1. Power off your computer.
2. Connect one end of the signal cable to
the LCD Monitor's VGA port or DVI port.
(See Fig. 1-4)
3. Connect the other end of the signal
cable to the VGA port or DVI port on
your PC.
4. Make sure both connections are secure.
ATTENTION
This device must be connected to an off-the-shelf video cable in order to comply with
FCC regulations. A ferrite-loaded interface cable is included in the LCD Monitor package.
This device will not be in compliance with FCC regulations when a non-ferrite-core video
cable is used.
14
from the rear of the monitor.(See Fig. 1.2,1-3)
Figure 1-2
Figure 1-3
Figure 1-4