Pioneer AVH-P6300BT Owner's Manual page 75

Installation
Antenna input
IP-BUS input
(Blue)
IP-BUS cable
26 pin cable (Supplied with Navigation system)
Insert the 26 pin cable in the direction
indicated in the figure.
Fuse resistor
Violet/white
Of the two lead wires connected to the back lamp, connect the one in which the
voltage changes when the gear shift is in the REVERSE (R) position. This connection
enables the unit to sense whether the car is moving forwards or backwards.
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that equipment. If not, keep the Audio Mute lead free of any connections.
Connection method
1. Clamp the lead.
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
Blue/white
Connect to system control terminal of the power amp or
auto-antenna relay control terminal (max. 300 mA 12 V DC).
With a 2 speaker system, do not connect anything to the speaker leads
that are not connected to speakers.
Note:
· Change the initial setting of this unit. The subwoofer output of this unit is monaural.
Pioneer IP-BUS
accessories
Navigation system
(AVIC-U220 (sold
separately)).
Please contact your dealer to inquire
about the connectable navigation system.
2. Clamp firmly with
needle-nosed pliers.
Power supply side
Ground side
Section
Parking brake
switch
En
16
75