DAELIM ET-300 Service Manual page 103

Remove starter reduction gear and shaft.
Pull out flywheel with A.C.G. flywheel puller.
flywheel puller
Special tool:
A.C.G. Flywheel puller
Remove flywheel and starting driven gear.
10-7 Starting Clutch
Starting Clutch Inspection
ID
Remove starting clutch driven gear.
Check the gear for wear or damage.
Measure the ID and OD of the starting clutch
driven gear.
Service Limit: ID: 25.1 mm
OD: 42.10 mm
OD
Check the starting reduction gear and shaft for
wear or damage.
Check each roller for wear or damage.