Cable Rubber Part Inspection; Storage Guide - DAELIM A-FOUR Brochure

Hide thumbs Also See for A-FOUR:
Table of Contents

Advertisement

CABLE RUBBER PART INSPECTION

A rubber part is assembled on the cable to
protect the inner cable.
Make sure that this part is placed firmly
around the correct part of the cable. When
washing the car, do not directly spray
water on to the rubber part is dirty, use a
dry cloth to clean this area.
INSPECTION PART
RUBBER
●Petrol is extremely flammable and
isexplosive under certain conditions.
Perform this operation in a well-
ventilated area with the engine
stopped. Do not smoke or allow
flames or sparks in the area where
petrol is drained or stored and where
the fuel tank is refueled.
46
PAY ATTENTION FOR CAR WASHING
●Be sure to stop the engine prior to car
washing.
●Be careful not to allow water to enter
the muffler during the washing.Water
inside the muffler may cause an
improper engine starting or rust
occurrence.
●Do not let water get inside the braking
system during the washing, as water
inside the brake system may weaken the
braking power. Upon completion of
washing, select a safe place where there
INSPECTION PART
is no traffic obstruction, and start the
vehicle.
Lightly apply the brake while driving at
a slow speed and check the braking
power. If the braking power has been
weak-ened, apply brake lightly while
driving at a slow speed to dry up the
brake system.
●Take precautions when waxing the
vehicle. Excessive polish of the painted
section and/or the resin part with
compound wax might damage the
painted section causing discoloration of
the affected area.

STORAGE GUIDE

Extended storage, such as for winter,
requires that you take certain steps to
reduce the effects of deterioration from
non-use of the motorcycle.
In addition, necessary repairs should be
made BEFORE storing the motorcycle;
otherwise, these repairs may be forgotten
by the time the motorcycle is removed
from storage.
<STORAGE>
●Empty the fuel tank into an approved
gasoline
container
commercially available hand siphon or
an equivalent method.
●If storage will last more than one
month, carburetor draining is very
important, to assure proper performance
after storage.
●Gasoline is extremely flammable and is
explosive
under
conditions. Perform this operation
in a well-ventilated area with the
engine stopped. Do not smoke or
allow flames or sparks in the area
where gasoline is drained or stored
and where the fuel tank is refueled.
using
a
certain

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents