Forwarding; Virtual Servers - TP-Link TL-WR2543ND User Manual

4.9

Forwarding

Figure 4-46 The Forwarding menu
There are four submenus under the Forwarding menu (shown in Figure 4-46): Virtual Servers,
Port Triggering, DMZ and UPnP. Click any of them, and you will be able to configure the
corresponding function.
4.9.1

Virtual Servers

Choose menu "Forwarding→Virtual Servers", and then you can view and add virtual servers in
the next screen (shown in
on your LAN. A virtual server is defined as a service port, and all requests from Internet to this
service port will be redirected to the computer specified by the server IP. Any PC that was used
for a virtual server must have a static or reserved IP address because its IP address may change
when using the DHCP function.
Service Port - The numbers of External Service Ports. You can enter a service port or a
range of service ports (the format is XXX – YYY; XXX is the Start port and YYY is the End
port).
Internal Port - The Internal Service Port number of the PC running the service application.
You can leave it blank if the Internal Port is the same as the Service Port, or enter a
specific port number when Service Port is a single one.
IP Address - The IP address of the PC running the service application.
Protocol - The protocol used for this application, either TCP, UDP, or All (all protocols
TL-WR2543ND 450Mbps Dual-Band Wireless N Gigabit Router
). Virtual servers can be used for setting up public services
Figure 4-47
Figure 4-47 Virtual Servers
- 62 -