Network; Lan - TP-Link TL-WR1043ND - Ultimate Wireless N Gigabit Router User Manual

Note:
The default PIN code of the Router can be found in its label or the QSS configuration screen as
.
Figure 4-2
c). You will see the following screen when the new device successfully connected to the

network.

Note:
a. The status LED on the Router will light green all the time if the device has been successfully
added to the network.
b. The QSS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the QSS.
4.5 Network
Figure 4-4 the Network menu
There are three submenus under the Network menu (shown in Figure 4-4 ): LAN, WAN and MAC
Clone. Click any of them, and you will be able to configure the corresponding function.

4.5.1 LAN

Choose menu "Network→LAN", you can configure the IP parameters of the LAN on the screen
as below.
TL-WR1043N/TL-WR1043ND
Figure 4-5 LAN
-23-
Wireless N Gigabit Router