Configuring The Port Check Settings - Symantec ALTIRIS REAL-TIME CONSOLE INFRASTRUCTURE 7.0 SP3 - V1.0 Manual

Configuring the port check settings

In this example, if a computer was turned off, the Restore State action turns off
the computer. If a computer was turned on, the Restore State action keeps the
computer turned on.
The Sample Job is an example of the Restore State power action usage in a job.
For this power action to work, you must configure the Task Input to use the output
from the previous power management task, as shown in the sample job. You can
use the Restore State power action only in a job.
See "Prerequisites for using Real-Time Console Infrastructure"
To view the Sample Job
1 In the Symantec Management Console, on the Manage menu, click Jobs and
Tasks.
2
In the left pane, click Samples > Real-Time Console Infrastructure > Sample
Job.
3 On the Sample Job page, under Jobs/Tasks, click the Run "Restore power
state" task.
4 Under Task Input , see how the task input is configured.
Real-Time Console Infrastructure includes a Port Check tool. This tool lets you
detect which ports are open on the target computer. You can run the Port Check
tool from a computer filter.
You can configure the port check settings that the Port Check tool uses. For
example, you can configure which ports to check.
To run the port check
1 In the Symantec Management Console, on the Manage menu, click Filters.
2 In the left pane, select a filter.
For example, click Computer Filters > All Computers.
3 In the right pane, right-click on a computer resource, and then click Remote
Management > Port check.
To configure port check settings
1
In the Symantec Management Console, on the Settings menu, click All
Settings.
2 In the left pane, click Remote Management > Real-Time Console
Infrastructure > Configuration Settings.
Using Real-Time Console Infrastructure
Configuring the port check settings
on page 10.
23