System Requirements - Cisco AIR-LAP1242AG-A-K9 Datasheet

All contents are Copyright © 1992–2006 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Item Specification
Security:
Other:
Antenna Connectors 2.4 GHz
5 GHz
Status LEDs
Dimensions
(W x L x H)
Weight
Environmental
System Memory
Input Power
Requirements
Powering Options
Power Draw 12.95W maximum
Note: 12.95W is the maximum power required at the powered device. If the access point is
being used in a PoE configuration, the power drawn from the power sourcing equipment will
be higher by some amount dependent on the length of the interconnecting cable. This
additional power may be as high as 2.45W, bringing the total system power draw (access point
and cabling) to 15.4W.
Warranty One year
Wi-Fi Certification

System Requirements

Table 3 lists the system requirements for Cisco Aironet 1240AG Series Access Points.
Table 3. System Requirements for Cisco Aironet 1240AG Series Access Points
Access Method Description
Browser Using the Web browser management GUI requires a computer running Internet Explorer
Version 6.0 or later, or Netscape Navigator Version 7.0 or later.
PoE Power sourcing equipment compliant with Cisco inline power or IEEE 802.3af, and providing
at least 12.94W at 48 VDC
ICES-003 (Canada)
VCCI (Japan)
EN 301.489-1 and -17 (Europe)
EN 60601-1-2 EMC requirements for the Medical Directive 93/42/EEC
802.11i, WPA2, WPA
802.1X
AES, TKIP
IEEE 802.11g and IEEE 802.11a
FCC Bulletin OET-65C
RSS-102
Dual RP-TNC connectors
Dual RP-TNC connectors
Status LED indicates operating state, association status, error/warning condition, boot
sequence, and maintenance status.
Ethernet LED indicates status of activity over the Ethernet.
Radio LED indicates status of activity over the radio.
6.6 x 8.5 x 1.1 in. (16.76 x 21.59 x 2.79 cm)
2.0 lbs
Non-operating (storage) temperature: –40 to 185°F (–40 to 85°C)
Operating temperature: –4 to 131°F (–20 to 55°C)
Operating humidity: 10 to 90 percent (non-condensing)
32 MB RAM
16 MB flash
100 to 240 VAC; 50 to 60Hz (power supply)
36 to 57 VDC (device)
Local power
802.3 AF switches
Cisco higher-power switches capable of supporting 13W or greater
Cisco Aironet power injectors (PWRINJ3 and PWRINJ-FIB)
Third-party PoE devices (must meet input power and power draw requirements)
Data Sheet
Page 7 of 9