Table of Contents
Advertisement
If either of the following happens, try the steps that follow:
•
Green System Tray icon
established.
•
The Device is not listed in the Universal Push2TV HD Manager screen.
Power is not applied to the Device: Make sure that the appropriate power supply is
connected to the power supply connector on the device side.
TV Adapter requires restart: Detach and re-attach the TV Adapter from the Display Adapter
to restart the hardware.
Wireless Device is out of range: If you experience frequent wireless link disconnection, the
Wireless Device might be out of range. Bring the Wireless Device closer to the Universal
Push2TV HD PC Adapter.
TV Adapter requires pairing: If you are adding a TV Adapter that was not part of a set, or if
you are connecting to a new unrecognized PC Adapter, you might need to perform the
Pairing procedure. See
Channel Busy
Problem/Question:
The Channel Busy message displays when I try to change the channel or after power-up or
insertion of the PC Adapter.
Symptom:
The host PC is showing the Channel Busy
the System Tray
Solution:
Another wireless system might be in use in proximity to the PC or to the device's
environment, and might cause temporary interference with the Universal Push2TV HD
system. Try to select a different channel (where applicable—local regulatory restrictions
might apply).
Close the message box, detach the PC Adapter from your PC, and re-attach it. If the
message displays again, try to change the channel again.
Note:
Manual channel selection might be restricted by local
communication regulation laws.
In Europe, there is currently only one channel available, and when
you try to use more than one set, they are trying to use the same
channel. In general, they should be able to share the same channel.
Push2TV HD Adapter
does not light up to indicate that a connection has been
Pairing
on page 42.
39
icon (Red with yellow exclamation mark) in
Advertisement
Table of Contents
